Spray desired amount of material onto surface while overlapping for complete coverage

Immediately begin moving towel in circular motion until dirt, grease and grime are dissolved. Repeat if necessary until satisfied.

Using clean side of towel, wipe any excess dirt, grime or InztaShine off from surface.

If streaks occur then grease dirt or grime is still present or excess InztaShine is left on the surface. Repeat the above steps; if streaks are still evident wipe with a damp cloth to remove excess InztaShine. Buff with a dry towel if desired.

For single count wipe pouch, tear open at pre slit marking. Pull wipe out and unfold wipe. For 10 count simply open the flip top and pull first wipe out and then reclose to prevent drying out.

Apply the wipe to the surface of any appliance and begin moving in any direction to begin removing grease, dirt and grime. Surfaces with a heavy layer of dirt, grease or grime will require more wipes.

Once wipe has removed the dirt grrease or grime begin rubbing surface with soft towel to buff in luster.

InztaShine is water soluble and may be rinsed with water and the surface dried again with soft towel.

If streaks occur then grease dirt or grime is still present and the steps above will have to be repeated till complete.

For single count wipe pouch, tear open at pre slit marking. Pull wipe out and unfold wipe. For 10 count simply open the flip top and pull first wipe out and then reclose to prevent drying out.

Apply the wipe to the surface of any appliance and begin moving in any direction to begin removing grease, dirt and grime. Surfaces with a heavy layer of dirt, grease or grime will require more wipes.

Once wipe has removed the dirt grease or grime begin rubbing surface with soft towel to buff in luster.

InztaShine is water soluble and may be rinsed with water and the surface dried again with soft towel.

If streaks occur then grease dirt or grime is still present and the steps above will have to be repeated till complete.

Spray desired amount of material onto surface while overlapping for complete uniform coverage. A uniform converage is achieved on these surfaces by overlapping spray pattern.

Immediately begin moving towel in circular motion or until dirt, grease and grime are dissolved. While rubbing some suds may be noticeable but this is normal. Continue rubbing until completely gone. Repeat if necessary until satisfied.

Using clean side of towel wipe any excess dirt, grime or InztaShine off from surface.

A buffing towel may be used now to rub until satisfied with finish. A thorough cleaning should be done following the above steps to ensure results.

If streaks occur then grease dirt or grime is still present and the steps above will have to be repeated till complete.